引用本文:赵海娟,张文洁,郑美玲,朱远洋,张峻松,李文伟.GC-MS法测定烟用包装材料中非邻苯酯类增塑剂[J].包装工程,2019,40(9):59-65.
【打印本页】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 4332次   下载 1531 本文二维码信息
码上扫一扫!
分享到: 微信 更多
GC-MS法测定烟用包装材料中非邻苯酯类增塑剂
赵海娟1, 张文洁2, 郑美玲2, 朱远洋2, 张峻松2, 李文伟1
1.河南中烟工业有限责任公司安阳卷烟厂,安阳 455000;2.郑州轻工业大学 食品与生物工程学院,郑州 450001
摘要:
目的 为测定烟用包装材料中非邻苯二甲酸酯类增塑剂的含量,建立气相色谱-质谱-离子扫描(GC/MS-SIM)技术同时测定烟用包装材料中12种非邻苯酯类增塑剂含量的检测分析方法。方法 采用二氯甲烷溶液为溶剂,振荡萃取烟用包装材料中的目标物,经GC-MS-SIM分析后,以苯甲酸苄酯为内标进行定量。结果 该方法在0.001~0.200 mg/g范围内线性良好,决定系数R2>0.999,检出限范围为1.2~7.2 μg/g,12种非邻苯二甲酸酯类增塑剂的回收率在90.63%~102.99%之间(RSD为0.71%~5.37%,n=5)。运用该方法测定采集到的12种烟用包装材料,检测到了5种非邻苯二甲酸酯类增塑剂,其含量范围分别为己二酸二乙酯(0~0.0200 mg/g)、磷酸三丁酯(0.1699~0.1783 mg/g)、磷酸三苯酯(0~0.0231 mg/g)、乙酰柠檬酸三丁酯(0.0062~9.0358 mg/g)、柠檬酸三丁酯(0~0.0198 mg/g)。结论 该方法便于操作,有较高的灵敏度,可满足快速准确分析的要求,适用于烟用包装材料中非邻苯二甲酸酯类增塑剂含量的检测分析。
关键词:  增塑剂  非邻苯二甲酸酯类  烟用包装材料  GC/MS-SIM
DOI:10.19554/j.cnki.1001-3563.2019.09.010
分类号:TS41+1;TS47
基金项目:河南中烟工业有限责任公司科技项目(ZW2015035)
Determination of Non-Phenyl Ester Plasticizers in Packaging Materials for Cigarettes by GC-MS
ZHAO Hai-juan1, ZHANG Wen-jie2, ZHENG Mei-ling2, ZHU Yuan-yang2, ZHANG Jun-song2, LI Wen-wei1
1.Anyang Cigarette Factory, China Tobacco Henan Industrial Co., Ltd., Anyang 455000, China;2.College of Food and Bioengineering, Zhengzhou University of Light Industry, Zhengzhou 450001, China
Abstract:
The paper aims to establish a method for simultaneous determination of 12 non-phenyl ester plasticizers in cigarette packaging materials by GC-MS-SIM to determine the content of non-phenyl ester plasticizers in cigarette packaging materials. The target substance in the cigarette packaging material was extracted by shaking with dichloromethane solution as the solvent, and ana-lyzed by GC-MS-SIM, and then quantified with benzyl benzoate as the internal standard. The results showed that the method had good linearity in the range of 0.001~0.200 mg/g, the determination coefficient R2>0.999, the detection limit range was 1.2~7.2 μg/g, the recovery rate of 12 non-phenyl ester plasticizers was between 90.63% and 102.99% (RSD=0.71% to 5.37%, n=5). This method was used to determine the 12 kinds of cigarette packaging materials collected, five kinds of non-phenyl ester plasticizers were detected, and their content ranges were DEA (0~0.0200 mg/g), TBP (0.1699~0.1783 mg/g), TPP (0~0.021 mg/g), ATBC (0.0062~9.0358 mg/g), TBC (0~0.0198 mg/g). The method is easy to operate, has high sensitivity, can meet the requirements of fast and accurate analysis, and is suitable for detection and analysis of non-phthalate plasticizer content in packaging materials for cigarettes.
Key words:  plasticizer  non-phenyl ester  cigarette packaging material  GC/MS-SIM

关于我们 | 联系我们 | 投诉建议 | 隐私保护

您是第24463923位访问者    渝ICP备15012534号-2

版权所有:《包装工程》编辑部 2014 All Rights Reserved

邮编:400039 电话:023—68792836传真:023—68792396 Email: designartj@126.com

    

  
 

渝公网安备 50010702501717号