引用本文:杨帅,康勇刚,齐菲.低温对聚乙烯发泡材料动态缓冲性能的影响[J].包装工程,2015,36(7):21-25.
【打印本页】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 2940次   下载 1782 本文二维码信息
码上扫一扫!
分享到: 微信 更多
低温对聚乙烯发泡材料动态缓冲性能的影响
杨帅, 康勇刚, 齐菲
天津科技大学,天津 300222
摘要:
目的 在低温环境条件下, 测试与分析2种冲击高度 (61, 76 cm) 下聚乙烯发泡材料的动态缓冲性能。方法 参考实际包装件流通环境的温度范围, 分别在23, 0, -15, -30 ℃等4种温度条件下进行聚乙烯发泡材料的动态冲击试验。结果 在低温环境条件下的EPE动态冲击曲线中, 对应于最小加速度处的静应力较常温条件下的增加0.9~2.5 kPa, 加速度值降低约7~8 g。结论 低温环境下, 缓冲材料动态载荷能力增加, 其最小加速度值低于常温条件下相同受力状态下的数值。在实际包装设计中, 应结合实际流通环境温度进行缓冲设计。
关键词:  发泡聚乙烯  低温  动态缓冲
DOI:
分类号:
基金项目:
Effect of Low Temperature upon Dynamic Cushioning Properties of EPE Foam Material
YANG Shuai, KANG Yong-gang, QI Fei
Tianjin University of Science and Technology,Tianjin 300222,China
Abstract:
Dynamic cushioning properties of Expanded Polyethylene (EPE) under low temperature conditions were tested and analyzed at drop heights of 61 cm and 76 cm, respectively. Dynamic shock tests of EPE foam material specimens at 23, 0, -15, and -30 ℃ were conducted according to the temperature range of the practical distribution. Compared with the ambient temperature, the static loading ability of the dynamic cushioning curves at low temperature was increased by about 0.9 to 2 kPa while the amplitude of acceleration was reduced by about 7 g to 8 g. In low temperature conditions, the loading ability of the EPE specimens increased while the minimum acceleration level was lower than that under the same force at the ambient temperature. It was recommended that the real temperature in distribution should be taken into account during the design of cushioned packages.
Key words:  expanded polyethylene  low temperature  dynamic cushioning properties

关于我们 | 联系我们 | 投诉建议 | 隐私保护

您是第24735334位访问者    渝ICP备15012534号-2

版权所有:《包装工程》编辑部 2014 All Rights Reserved

邮编:400039 电话:023—68792836传真:023—68792396 Email: designartj@126.com

 

渝公网安备 50010702501717号